I put the wooden bead on first, making sure it was in the centre of the cord. Then the largest button went on, after that one of the smallest ones, and then a large one again, as the trick to making this look like a spruce/Christmas tree and not a cone is alternating the buttons of a decreasing size with really small ones.
These little ornaments are a bit whimsical, but cute. They also make a nice craft for children. Remember those bags of non-matching buttons I mentioned in my last post? A while back I decided to get some use out of the green ones. I apologise for the poor quality of the WIP images, the lighting was pretty bad.
The supplies I used were green buttons of varying sizes, wooden beads for the trunks, yellow glass beads for the toppers (star shaped buttons are nice too, but I was working from stash), and I stringed the ornaments on green linen thread that I’d twisted to make thin cords.
For buttons with two holes the cord naturally will run through each of them, and on four hole buttons, the cord will go through two holes diagonally across from each other. When all the buttons are stringed, add the bead on top, tie off the cord (make sure the knot is big enough to prevent the glass bead from slipping off), and your ornament is done!
This is a great project for left-over buttons, and if the buttons don’t match from one tree to another it’s actually not a bad thing, as no two trees look exactly the same in real life. If one would someday want the buttons for something else, they are easily redeemable.
Have you made a neat holiday craft using buttons? Please share!